DeniseRN_TPA said:Concentration choice is a precision decision, not a preference.
Regarding dosing arithmetic multi-dose vial contamination prevention: after reconstituting, I wipe the vial stopper with a fresh alcohol swab before EVERY single draw. I also never touch the stopper with my fingers and use a new needle for each draw.
Even with bacteriostatic water preservative, contamination is cumulative. One sloppy draw can introduce bacteria that multiply over days. Aseptic technique isn't optional — it's essential for injectable medications.
One thing that is still open after BariatricNurseD’s answer:
How much material I am losing to dead space, and whether that explains why a 10mg vial gives me nine usable draws rather than ten?
DoseLogDan said:Regarding dosing arithmetic multi-dose vial contamination prevention: after reconstituting, I wipe the vial stopper with a fresh alcohol swab before…
Reconstitution tip for anyone mixing dosing arithmetic from lyophilized powder: use bacteriostatic water, NOT sterile water. The benzyl alcohol in BAC water preserves multi-dose vials for up to 28 days.
Inject the water slowly down the side of the vial. NEVER shake — gentle swirling only until fully dissolved. Should be crystal clear with no particles.
Sigma-Aldrich — Research-Grade Standards
Certified reference materials, analytical reagents, and research-grade standards for peptide verification. Trusted by laboratories worldwide.
Shop Reference StandardsReporting back.
My error was treating units as a mass. Once I wrote mg/ml on the vial in marker and worked in millilitres first, the two of us got the same answer.
SarahChen_PharmD said:Reconstitution tip for anyone mixing dosing arithmetic from lyophilized powder: use bacteriostatic water, NOT sterile water.
Agreed, and it is worth saying that rounding to the nearest whole unit is usually acceptable at maintenance doses and is not acceptable at the bottom of a ladder, where one unit can be a fifth of the intended dose.